微氧化烧结制备掺杂Y2O3的SiC陶瓷及含镉模拟废水处理

采用了微氧化烧结制备了不同Y₂O₃质量分数（0%、2%、4%、6%）的多孔SiC陶瓷，通过对陶瓷的晶体结构、微观形貌、物理性能和Cd²⁺的去除率测试发现：添加了Y₂O₃的SiC陶瓷出现了较多的第二相Y₂SiO₇、Y₅Si₃C_0.5，随着Y₂O₃的质量分数增加逐渐升高，主相的衍射峰的强度有降低。扫描电子显微镜测试发现，SiC陶瓷的尺寸在2.5 μm，Y₂O₃引入后，SiC陶瓷的晶粒尺寸降低，高温烧结时液相的含量增加，熔体粘度降低，晶粒结合更加紧密，Y₂O₃的引入提高了多孔陶瓷的体积密度，Y₂O₃质量分数为6%SiC的体积密度最大为2.21 g/cm³。热导率随着Y₂O₃质量分数的增加呈现出先升高后降低的趋势。金属Cd²⁺的过滤测试表明：随着Y₂O₃质量分数增加，Cd²⁺的残留质量浓度、膜通量和去除率先降低后升高，当掺杂质量分数为4%时，Cd²⁺残留质量浓度最低为0.042 mg/L，膜通量达到了最大值572 L/（m²·h），去除率最大为99.95%，相比未掺质量分数杂体系的去除率提高了0.14%。随着溶液pH值的逐渐增大，金属Cd²⁺的残留质量浓度逐渐降低、去除率逐渐升高，pH≥9时最终均趋于稳定。综合来看，多孔SiC陶瓷的助烧剂Y₂O₃最佳掺量为4%。     

碳量子点/曙红Y比率型荧光探针测定L-抗坏血酸

以天然生物质去皮的蓖麻为碳源,采用一步水热法合成了荧光性能优良的绿色荧光蓖麻碳量子点(CO-CQDs),对其形貌和发光性能进行了表征。通过将该CO-CQDs与荧光极强的卤代荧光素染料曙红Y(EY)复合,二者可形成荧光发射峰相距较远的新型CO-CQDs/EY复合物。在pH=4.00的Na2HPO4-柠檬酸缓冲溶液中,在320 nm的激发波长下,CO-CQDs/EY复合物于405 nm和540 nm处显示出两个独立的荧光发射峰。在该体系中加入Cr(Ⅵ),405 nm和540 nm两处的荧光信号均显著猝灭。L-抗坏血酸(L-ascorbic acid,AA)的加入可使复合物于540 nm的荧光信号恢复,而405 nm处的荧光强度基本不变。据此建立了一种以CO-CQDs/EY复合物为比率型荧光探针测定AA的新方法。实验测定了荧光信号恢复的最佳条件和影响荧光恢复的因素,初步探讨了反应机理。在优化的实验条件下,该探针于540 nm/405 nm两处的荧光强度比值与AA的浓度在5.0×10^-8~4.0×10^-6 mol/L范围内呈良好线性关系,检出限为3.7×10^-8 mol/L。该探针用于检测药物、水果和蔬菜中AA的含量,结果满意。     

Dynamics of partially obstructed breakup of bubbles in microfluidic Y‐junctions

For revealing the dynamics of partially obstructed breakup of bubbles in microfluidic Y‐junctions, the combination of dimensionless power‐law and geometric model was applied to study the effects of capillary number, bubble length, and channel angle on the bubble rupture process. In the squeezing process, the gas‐liquid interface curve follows the parabolic model. For the evolution of the bubble neck during breakup, the increase of the bubble length, the channel angle, and the capillary number leads to the decrease of the focus distance α. The chord m increases with the increase of the capillary number and the decrease of the bubble length, and it would reach the maximum value when the channel angle is 90°. In the fast pinch‐off stage during bubble breakup, the bubble's neck curve no longer conforms to the parabolic model so the focus and chord no longer exist. For the evolution of the bubble head during breakup, the value of γ approaches 1 with the increase of the capillary number and the bubble length, and with the close of the channel angle to 90°. It is found that the quadrilateral model can be applied for the partially obstructed rupture of bubbles in the symmetrical microfluidic Y‐junction.     

Calculated coupling constants 1J(X–Y) and 1K(X–Y), and fundamental relationships among the reduced coupling constants for molecules HmX–YHn,with X,Y ═ 1H, 7Li, 9Be, 11B, 13C, 15N, 17O, 19F, 31P, 33S,and 35Cl

Equation-of-motion coupled-cluster singles and doubles (EOM-CCSD) calculations have been performed to determine coupling constants ¹J(X–Y) for 65 molecules H_mX–YH_n, with X,Y ═ ¹H, ⁷Li, ⁹Be, ¹¹B, ¹³C, ¹⁵N, ¹⁷O, ¹⁹F, ³¹P, ³³S, and ³⁵Cl. The computed ¹J(X–Y) values are in good agreement with available experimental data. The reduced coupling constants ¹K(X–Y) have been derived from ¹J(X–Y) by removing the dependence on the magnetogyric ratios of X and Y. Patterns are found for the reduced coupling constants on a ¹K(X–Y) surface that are related to the positions of X and Y in the periodic table.     

Y掺杂WS2二维材料的第一性原理研究

WS₂由于其优异的物理和光电性质引起了广泛关注。本研究基于第一性原理计算方法,探索了本征单层WS₂及不同浓度W原子替位钇(Y)掺杂WS₂的电子结构和光学特性。结果表明本征单层WS₂为带隙1.814 eV的直接带隙半导体。进行4%浓度(原子数分数)的Y原子掺杂后,带隙减小为1.508 eV,依旧保持着直接带隙的特性,随着Y掺杂浓度的不断增大,掺杂WS₂带隙进一步减小,当浓度达到25%时,能带结构转变为0.658 eV的间接带隙,WS₂表现出磁性。适量浓度的掺杂可以提高材料的导电性能,且掺杂浓度增大时,体系依旧保持着透明性并且在红外光和可见光区对光子的吸收能力、材料的介电性能都有着显著提高。本文为WS₂二维材料相关光电器件的研究提供了理论依据。     

Genetic diversity and haplotype structure of 21 Y‐STRs,including nine noncore loci,in South Tunisian Population: Forensic relevance

Y chromosome STRs (Y‐STRs) are being used frequently in forensic laboratories. Previous studies of Y‐STR polymorphisms in different groups of the Tunisian population identified low levels of diversity and discrimination capacity (DC) using various commercial marker sets. This definitely limits the use of such systems for Y‐STRs genotyping in Tunisia. In our investigation on South Tunisia, 200 unrelated males were typed for the 12 conventional Y‐STRs included in the PowerPlex® Y System. Additional set of nine noncore Y‐STRs including DYS446, DYS456, DYS458, DYS388, DYS444, DYS445, DYS449, DYS710, and DYS464 markers were genotyped and evaluated for their potential in improving DC. Allele frequency, gene diversity, haplotype diversity (HD), and DC calculation revealed that DYS464 was the most diverse marker followed by DYS710 and DYS449 markers. The standard panel of 12 Y‐STRs (DC = 80.5%) and the nine markers were combined to obtain DC of 99%. Among the 198 different haplotypes observed, 196 haplotypes were unique (HD = 99.999). Out of the nine noncore set, six Y‐STRs (DYS458, DYS456, DYS449, DYS710, DYS444, and DYS464) had the greatest impact on enhancing DC. Our data provided putative Y‐STRs combination to be used for genetic and forensic applications.     

催化裂化条件下噻吩与改性Y分子筛的作用机制

以HY、NiY和稀土离子改性的Y分子筛(REY)为研究对象,采用固定床装置评价噻吩模拟油催化裂化性能;运用气相色谱-氢火焰离子发光检测器(GC-FID)、气相色谱-硫化学发光检测器(GC-SCD)和原位红外光谱技术分析产物,关联分子筛的酸性,研究催化裂化条件下噻吩与改性Y分子筛的作用机制。实验结果表明,催化裂化条件下,噻吩与分子筛的作用机制差异主要取决于与B酸或L酸相关的非骨架铝物种或金属离子物种的存在形式。其中,NiY分子筛中,噻吩主要是吸附在与NiOH⁺物种相关的L酸中心,而Ni₄AlO₄³⁺等物种减弱B酸性中心从而降低其裂化性能。对HY来说,噻吩易在与AlO⁺等物种相邻的B酸中心上聚合形成三联噻吩,并发生一定的氢转移和裂化反应;而对REY而言,分子筛中与RE物种相关的L酸位会促进噻吩在与非骨架铝羟基等物种(如Al(OH)₂⁺、Al(OH)²⁺等)相邻的B酸中心形成的二联噻吩发生氢转移和裂化反应。     

以四乙基氢氧化铵为模板并通过转晶法合成高硅铝比的SSZ⁃13沸石分子筛

使用四乙基氢氧化铵为有机模板剂,以低硅铝比(nSiO2/nAl2O3)的Y分子筛为铝源,通过转晶法制备结晶度良好的SSZ?13沸石分子筛。从凝胶配比方面考察了不同原料组成对分子筛合成的影响,并通过X射线衍射(XRD)、扫描电子显微镜(SEM)及电感耦合等离子体(ICP)表征水热反应过程中的物相、形貌、硅铝比等变化,揭示分子筛合成过程。氨选择性催化还原(NH3?SCR)反应显示该分子筛具有优异的催化活性,为其工业上的广泛应用提供了可能性。     

改性Y型分子筛对硫醇硫醚的吸附脱除研究

通过液相离子交换法制备了Cu(I)Y、Ni Y、Ce Y分子筛,以XRD、低温N2吸附-脱附、NH3-TPD、吡啶红外Py-FTIR等方法对其进行物性表征。利用固定床技术、WK-2D微库伦仪及硫化学发光检测GC-SCD色谱评价了改性分子筛对于硫含量300μg/g模拟油(含硫化合物二丙硫醚、环己硫醇和1-庚硫醇与壬烷配制)及HDS汽油的吸附脱硫性能。结果表明,吸附剂对模拟油和HDS燃料油品中硫醇硫醚具有吸附效果,且改性后的分子筛在吸附脱硫过程中,强的B酸对于吸附脱硫有负作用,会使油品中硫醇硫醚发生催化反应,聚合的大分子硫化物遮盖及阻塞吸附活性位点,从而使吸附剂不能够完全地吸附硫化物,造成吸附硫容较小,而弱L酸无催化活性对吸附脱硫有正面影响。